Specifications

Command Line Interface
102
Command: set
module redloa
Description: Set the Loss of Activity (LOA) time in seconds
(0-31) on a 1000Mbps redundant line card.
With SONAR enabled, if the active port remains
idle longer than the time specified, the card will
check for activity on the secondary port and
switchover if activity is detected.
Syntax: set module redloa <chassis> <module> <time>
Note: Time is any number from 0 to 31.
Example: Console>set module redloa 1 16 10
LOA time successfully set.
Command: set
module
redmode
Description: Set the mode of a redundant interface line card.
Syntax: set module redmode <chassis> <module>
<DynamicRecovery | SelectAB>
Note: Dynamic Recovery mode provides automatic
switchover for port failure redundancy while
selectAB provides a basic A/B port selector.
This status is relevant to several other ‘set
module’ commands.
Example: Console>set module redmode 1 11 SelectAB
Mode Control successfully set.
Command: set
module redtx
Description: Set the transmission status of a redundant
interface line card.
Syntax: set module redtx <chassis> <module> <enable
| disable>
Note: The ability of the primary and secondary output
ports to transmit the received main input signal
simultaneously; must be in Dynamic Recovery
mode.
Example: Console>set module redtx 1 11 enable
Transmission Mode successfully set.