Specifications

101
Admin Privilege Commands
Command: set
module portllcf
Description: Enable or disable Link Loss Carry Forward one
of the ports on a local or remote services line
card.
Syntax: set module portllcf <chassis> <module> <port>
[<rmtModule> <rmtPort>] <enable | disable>
Example: Console>set module portllcf 1 2 1 enable
Port LLCF Successfully set.
Command: set
module
portmgmt
Description: Enable or disable the ability to receive
management frames on one of the ports on a
local or remote services line card.
Syntax: set module portmgmt <chassis> <module>
<port> [<rmtModule> <rmtPort>] <enable |
disable>
Example: Console>set module portmgmt 1 2 1 enable
Port management Successfully set.
Command: set
module
redabsel
Description: Set the output port A (Primary) or B
(Secondary) for a redundant interface line card.
Syntax: set module redabsel <chassis> <module>
<selectA | selectB>
Note: The mode of the redundant interface line card
must be selectAB. (See Command: set module
redmode for details.)
Example: Console>set module redabsel 1 11 selectA
ABSelect successfully set.
Command: set
module redlink
Description: Set the Link Pulse Control on a redundant line
card. Link pulses are sent on the inactive port
when enabled.
Syntax: set module redlink <chassis> <module>
<enable | disable>
Note: Must be in Dynamic Recovery mode.
Example: Console>set module redlink 1 11 enable
Link Pulse Control successfully set.