User guide

10 Installation Guide

Install the SFP Optics

The R752-1S and R752-SS require two or three sets of small form-

factor pluggable (SFP) optics. Each set of optics is shipped separately.

To install the optics, slide the SFP module into an empty slot, pushing it

firmly in place. Remove the protective covering on the LC connectors.

Install the Line Card

Radiance line cards offer the ease of plug-and-play installation and are

hot-swappable. All cards must be firmly secured to the chassis before

network connections are made. Follow the simple steps outlined below

to install the redundant interface line card.

• Grasp the card by the front panel as shown.

• Insert the card into a slot on the chassis making sure that the top and

bottom edges of the circuit board are aligned with the top and bottom

card guides in the chassis. Do not force the card into the chassis

unnecessarily. It should slide in easily and evenly.

• Slide the card in until the top and bottom edges of the front panel are

flush and even with the top and bottom edges of the chassis.

1000 BASE

SEC

PWR

RESET