User guide

Radiance R400 Premise Service Platform 9
4
• Line the edges of the board with the slot guides and slide the card in
until the edges are flush and even with the front of the unit. Do not
force the card into the slot unnecessarily. It should slide in easily and
evenly.
• Secure to the platform by turning the thumb screw clockwise until
snug. The line card is now ready for connection to the network.
Connect to the Network
Connecting the Management Card
The management card supports 10Base-T Ethernet.
• Using a standard Category 3, 4, or 5 UTP cable, connect the manage-
ment card to your network. The port can be configured for either full
or half duplex, however, half duplex is recommended. Refer to the
Command Line Interface Reference Guide for a detailed description
of configuration commands.
• Using the supplied null-modem console cable, connect the male DB-
9 port on the management card to the serial port on your PC.
Connecting the Line Cards
To connect the individual cards to the network, refer to their correspond-
ing installation and user guides.
Attach the Grounding Lug (Optional)
On its back panel, the R400 has a small hole where a grounding lug can
be installed. The hole is marked with the grounding symbol. Use a 6-32
screw to fasten the lug (not provided) to the platform. Connect the other
end of the grounding lug wire to the grounding point at your site.
5