User guide

8 Installation Guide
3
Install the Line Cards
The R400 Premise Service Platform supports two single-slot Radiance
line cards in any combination. These cards offer the ease of plug-and-
play installation and are hot-swappable. Refer to each card’s documen-
tation for detailed installation instructions.
Before installing any card, note the following:
• Remove the temporary slot protectors by turning the thumb screws
counterclockwise and removing the blank panels.
• Line cards can be installed into either slot.
• All switches and jumpers on the cards must be set prior to installa-
tion. Refer to each card’s documentation for a complete description
of its settings.
• Proper grounding is recommended (i.e., wrist strap).
• Both line cards must be firmly secured to the platform before
network connections are made.
Follow the simple steps outlined below to install the line cards:
• Grasp the card by the front panel as shown (thumb screw to the
left).
Card Guide
L
K
A
T
P
W
R
A B
R
E
R
C
O
N
S
O
L
E
P
W
R
R
X
R
X
L
K
L
K
M
M
T
X
T
X
F
F
X
L
M
M
SLOT 1
MGT-10
10/100
L
K
A
T
1
2