User guide

Radiance DIN Rail Mounted Chassis 9

Connect to the Network

Connecting the Line Cards

To connect the individual line cards to the network, refer to their

corresponding installation and user guides.

Connecting the Management Line Card

If a management line card is installed in your chassis, follow the

procedure below to connect to the network. The management line card

supports 10Base-T Ethernet.

• Using a standard Category 3 or 5 UTP cable, connect Port 1 on the

management card to your network. Although the two Ethernet ports

can be configured for either full or half duplex, half duplex is

recommended. Refer to the Command Line Interface Reference

Guide for a detailed description of configuration commands.

• Using the supplied null-modem console cable, connect the male DB-

9 port on the management card to the serial port on your PC.

• For instructions on stacking, refer to the Command Line Interface

Reference Guide.