User guide

8 Installation Guide
4
Install the Line Cards
The Radiance DIN rail mounted chassis supports any two single-slot
interface line card or one double-slot redundant interface line card.
Radiance line cards offer the ease of plug-and-play installation and are
hot-swappable.
Before installing any card, note the following:
• Set all switches and/or jumpers on the line card. Refer to the card’s
user guide for detailed configuration instructions.
• A blank panel is installed in the chassis. Do NOT remove the panel
unless you are installing two line cards. To remove the blank panel,
turn the thumbscrew counterclockwise until loosened.
Follow the simple steps outlined below to install a line card:
• Grasp the card by the front panel as shown.
• Line the edges of the board with the top and bottom card guides, and
slide the card in until the edges are flush and even with the front of
the unit. Do not force the card into the slot. It should slide in easily
and evenly.
• Secure to the chassis by turning the thumb screw clockwise until
snug. The line card is now ready for connection to the network.
Card
Guide
IMPORTANT!
Tighten thumb screw
to secure each card firmly
to chassis before making
network connections.
R
X
T
X
LK
PWR
1000 BASE
1
AT
2
LK
AT
1
Blank
Panel