User guide

8 Installation Guide

Connect to the Network

Connecting the Line Cards

To connect the individual line cards to the network, refer to their

corresponding installation and user guides.

Connecting the Management Line Card

If a management line card is installed in your platform, follow the

procedure below to connect to the network. The management line card

supports 10Base-T Ethernet.

• Using a standard Category 3 or 5 UTP cable, connect the line card to

your network. Although the Ethernet port(s) can be configured for

either full or half duplex, half duplex is recommended. Refer to the

Command Line Interface Reference Guide for a detailed description

of configuration commands.

• Using the supplied null-modem console cable, connect the male DB-

9 port on the management card to the serial port on your PC.

Attach the Grounding Lug (DC models only)

On the back panel, the R1000 provides two horizontal grounding points

where a grounding lug must be installed. Use a Panduit

copper,

standard barrel, two-hole lug (part number LCD8-10A-L) or its

equivalent. Use two 10-32 screws to fasten the lug to the platform. Use

a No. 8 AWG copper wire to connect the lug to the grounding point at

your site.

DISCONNECT ALL POWER SOURCES BEFORE SERVICING

DC IN

48V DC

1.3A

DC PWR

RISK OF ELECTRIC

SHOCK, DO NOT OPEN

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES,

OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,

INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

CAUTION

I.T.E.

E116552

LISTED