User`s guide

Installation Guide 9
Connect to the Network
The Metrobility 10/100Mbps Delta Class AutoTwister offers the ease of
plug-and-play installation. The overhang extension provides built-in
protection for the two cable connectors.
When making network connections with the AutoTwister, grasp the end
of the cable with your index finger on the top of the connector and your
thumb on the bottom, as shown in the illustration below. For easier
installation, insert the copper cable to the AutoTwister before connecting
the fiber.
II
x
Twisted-Pair Connection
Each AutoTwister provides one shielded RJ-45 connector that supports a
maximum segment length of up to 100 meters. Use Category 3, 4 or 5
cables for 10Mbps segments; use only Category 5 or 5E cables for
100Mbps segments.
NOTE: Be sure to properly set the MDI-II/MDI-X switch located between
the two port connectors. Refer back to Set the Switches: MDI-II/MDI-X
Switch if necessary.
RJ-45