User`s guide

12 Metrobility 10/100Mbps Delta Class AutoTwister
Apply Power
Power is applied to the AutoTwister through the desktop power supply. To
apply power, do the following:
1. Connect the power cord (not included with interna-
tional shipments) to the power supply.
2. Connect the power supply to the AutoTwister’s DC
input power jack located on the back of the unit.
3. The AutoTwister is designed with built-in cable
management and protection. Turn the unit upside-
down and route the DC power cord into one of the
two grooves located on each side of the unit. See
diagram.
4. Plug the power cord into an AC
wall outlet. Upon receiving
power, the power (PWR) LED
turns green and the Auto-
Twister automatically goes into operation providing the appropriate
signal translation between connected network segments.
5. Verify valid connections via the link (LK) LEDs, which should be lit.
While one end of the AC power cord can be fitted with a plug standard
for the country of operation, the end that connects to the AutoTwister’s
power supply must have a female plug that fits the following type of AC
receptacle.
• AC 115V (North America): Use a UL-listed and CSA-certified cord set
consisting of a minimum No. 18 AWG, type SVT or SJT three-
conductor cord (15 ft maximum length) and a parallel blade grounding
type attachment plug rated 15A, 125V.
• AC 230V (USA): Use a UL-listed cord set consisting of a minimum No.
18 AWG, type SVT three-conductor cord (15 ft maximum length) and a
Tandem blade grounding type attachment plug rated 15A, 250V.
• 240V (outside USA): Use a cord set consisting of a minimum No. 18
AWG cord and grounding type attachment plug rated 15A, 250V. The
cord set should have the appropriate safety approvals for the country
in which the AutoTwister is being installed and be marked HAR.