User guide

“twister” 2131 Multimode-to-Singlemode Media Converter 9
Apply Power
Power is provided to the “twister” unit from the desktop power supply
module. This power module is equipped with a S760 hollow-type plug for
insertion into the DC jack located on the back of the “twister” unit and
standard IEC 320-type AC power receptacle.
When making power connections, it is recommended that the
DC power cord be connected to the DC input jack located on the back of the
“twister” media converter before making the AC connection to the outlet.
Be sure to seat the power cord into the strain relief clip to ensure against
accidental disconnection.
5
PWR
OFF ON
DC INPUT/5VDC
LLCF
Strain Relief Clip
Upon receiving power, the “twister” media converter goes into normal
operation mode and automatically provides the appropriate signal transla-
tion between the connected network segments.
Be sure to verify correct segment connectivity via the link (LK) LEDs on
the front of the unit.
If an additional extension cord is used to connect the power module to the
power source, the following guidelines must be followed.