Operation Manual

Portable 4000 count digital multimeter

1.6 Unpacking - Repackaging

This equipment has been fully checked out mechanically and

electrically before shipping.

All precautions have been taken to ensure that the instrument arrives

at its destination undamaged.

However, it is advisable to carry out a rapid check for damage

sustained in shipping. If there is any evidence of damage, make this

known immediately to the shipper.

 Should you need to return the multimeter, preferably use the

original packaging and indicate the reasons as clearly as

possible on an accompanying note.

1.7 Cleaning

Clean the instrument using a damp cloth and soap. Never

use

abrasive or solvents.

1.8 Replacing the battery or fuses

 First disconnect test leads from any circuit under test, turn the

meter off and remove test leads from the input terminals .

Use the following procedure :

1 - Using an appropriate tool, slide off the case bottom of the

instrument.

2 - Replace the battery or the fuse.

3 - Replace the removable part.

 HBC fuses must be replaced by fuses of the same rating and type.

BATTERY 9 V

6LF22

F1 0.63 A, HBC

18 kA / 600 V

F2 10 A, HBC

50 kA / 600 V