Manual

Messages
Two-channel digital Oscilloscopes 91
Messages / Help (cont'd)
Messages
 Trig level at limit!: Indicates that the Trigger Level, adjustable by the Trig
level knob, has reached a limit.
 Horizon position at limit!: Indicates that the horizontal position, adjustable
by the horizontal position knob, has reached a limit.
 Volts/Div at limit!: Indicates that the vertical range has already reached the
minimum of 2mV/div or the maximum of 10V/div.
 Volts position at limit!: Indicates that the vertical position has reached a
limit.
 Sec/Div at limit!: Indicates that the time base range, S/div, has reached a
limit.
 Hold-Off time at limit!: Indicates that the Hold-Off time, adjustable by the
adjust knob, has reached a limit
 Function isn’t useable!: Indicates that the function is not compatible with
this operating mode.
 No signal!: This message is displayed upon completion of the Autoset when
there is no signal.
 Adjust at limit!: This message is displayed when the pulse width adjustment
(by the adjust knob) has reached the minimum of 20.0ns or the maximum of
10.0s.
 Location Empty!: This message is displayed if you press the restore key and
no Trace or Configuration is stored at this location.
 USB Flash Drive Plug In!: This message is displayed when you insert a USB
Flash Drive in the USB host port.
 USB Flash Drive Pull Out!: This message is displayed when you disconnect
the USB flash memory.
 Store Data Success!: This message indicates a "Successful Save" of the
configuration, of the Trace, or of the image to the internal memory of the
oscilloscope or to the USB key.
 Read Data Success!: This message indicates a "Successful Recall" of the
configuration or of the trace from the internal memory of the oscilloscope or
from the USB flash memory.
 Please set Back USB to printer!: This message is displayed if the "S/div"
knob is pressed with "Printing" configured to "Print Picture" and the "Back
USB" option set to "USBTMC".
 USB Flash Drive isn’t connected!: This message is displayed when the
USB key is not inserted in the USB host port and the "Save to" option is set to
"File" or the "Printing" option is set to "Save Picture" in the "Save/Restore"
menu and you press the "Save" key or the "S/div" knob.
 Record Wave Success!: This message is displayed at the end of successful
recording of traces.