Manual

Functional description
84 Two-channel digital Oscilloscopes
Functional description
VIII - UTILITY 4/4
Record mode
The Record mode is used to record up to 2500 frames of 2.5 kpoints with time base
ranges from 50ms/div to 2.5ns/div. The Record mode is the complement of the
Recorder mode, which for its part is suited to slow signals and operates with time
base ranges from of 100ms/div to 50s/div.
The Record mode is used to record the signals of channel CH1 or CH2 with a
maximum record length of 2500 points. Recording can for example be triggered by
an output of the pass/fail test signal, which makes this function very useful for
recording slow signals for long periods without having to observe them
continuously.
Signal recorder: Record signals at the defined rate.
Option
Values
Instruction
Mode
1. Record
2. Replay
3. Off
Select Recorder mode
Select replay mode.
Exit from the signal recorder mode.
Source
CH1
CH2
Pass/Fail-OUT
Choose the source channel for recording.
Interval
Set the time interval between frames.
End frame
Maximum number of frames
Use
(Record)
(Stop)
Press to start recording.
Press to stop recording.
Steps
1. Press the UTILITY key to access the "Utility" menu.
2. Press the "Next Page" key to access the third page of the "Utility" menu.
3. Press the "Record" key to open the "RECORD" menu.
4. Press the "Mode" key and choose "Record".
5. Press the "Source" key to choose the input signal channel.
6. Choose "Interval" and turn the "Adjust" knob to adjust the time interval between
two successive frames.
7. Choose "End frame" and turn the "Adjust" knob to adjust the maximum number
of frames to be recorded.
8. Press " " of the "Use" option to record the signal.
Reading: Read the current record, or read saved records.