Manual

Functional description
70 Two-channel digital Oscilloscopes
Functional description
VII - STORAGE system (cont'd)
3.2 Save/Restore
Traces in USB flash
memory
Option
Configuration
Description
Type
Curves
Save/Recall menu.
Save to
Folder
Save the trace to the USB key.
Save
Run the backup.
Save
To save a trace in USB flash memory:
Steps
1. Inject a signal on channel CH1 and press the "AUTO" key.
2. Press the "SAVE/RECALL" key to display the "SAVE/RECALL" menu.
3. Press the "Type" key and choose "Curves".
4. Insert the USB key in the host USB port of the oscilloscope and wait for the
oscilloscope to initialize the USB flash memory (approximately five seconds).
5. Press the "Save To" key and choose "Folder".
6. Press the "Save" key to access the Save/Recall interface.
7. Create a file and then press the "Confirm" button (after approximately five
seconds a "Save data success" message is displayed on screen). The trace
has been saved in the USB flash memory.
Restore
To restore a signal from the USB flash memory:
Steps
1. Press the “SAVE/RECALL” key.
2. Press the "Type" key and choose "Curves".
3. Insert the USB key in the host USB port of the oscilloscope and wait for the
oscilloscope to initialize the USB flash memory (approximately five seconds).
4. Press the "Save" key and choose "Folder".
5. Press the "Load" button to access the Save/Restore interface.
6. Choose the desired file and press the "Load" button (after approximately
five seconds, a "Read data success" message is displayed). The trace has
been restored from the USB memory.