Manual

Description of the instrument
Two-channel digital Oscilloscopes 7
Description of the instrument (cont'd)
Display interface
1.
Trigger status:
Set: The oscilloscope is in pre-trigger data acquisition. All triggers are
ignored in this status.
Ready: All pre-trigger data have been acquired and the oscilloscope is ready
to accept a trigger.
Trig’d: The oscilloscope has detected a trigger and is in post-trigger data
acquisition.
Stop: The oscilloscope stops the acquisition.
Auto: The oscilloscope is in "Auto" mode and triggers acquisitions even in
the absence of a triggering event.
Scan: The oscilloscope acquires and displays data continuously in Roll
mode.
2.
USB key detected
3.
Displays the position in the internal memory of the window displayed.
4.
Indicates the horizontal position of the trigger, to change it turn the horizontal
position button
5.
Indicates that the LAN interface (rear panel) is active or not
6.
Displays the trigger level icon
7.
Displays the channel icon
8.
Displays the input coupling icon
9.
Displays the vertical scale of the track
10.
Indicates the status of the bandwidth limitation filter. The letter "B" indicates
that the bandwidth is limited to 20MHz.
11.
The display shows the calibration of the main time base
12.
Displays the trigger type
13.
Indicates the horizontal position of the Trigger relative to the center of the
screen
14.
Indicates the trigger level in Volts
15.
Indicates the frequency of the trigger source signal
6
7
15
14
8 9 10 11 13 12
1 2 3 4 5