Manual

Functional description
Two-channel digital Oscilloscopes 13
Functional description
AUTOSET
AUTOSET
The DOX2000B digital oscilloscope has an "AUTOSET" function that is used
to automatically configure the device to produce a display appropriate to the
signals present on the inputs.
After starting an AUTOSET, if necessary, select the desired signal waveform
from among the 4 available:
Autoset
function menu
Option
Description
Multi cycles
Autoset and display of the signal for
several cycles.
Monocycle
Autoset and display of a single cycle
of the signal.
Rising edge
Autoset and display of the rising edge.
Falling edge
Autoset and display of the falling
edge.
Cancel config.
Restores the previous configuration of
the oscilloscope.
The Autoset defines the triggering source and the display of the channels to
satisfy the following conditions:
● If the signals on the inputs are of different frequencies, the priority
channel is the one in which the signal has the lower frequency.
● If no signal is detected, it is the channel having the lower index (CH1) that
is displayed.
● If no signal is found and no channel is activated, the oscilloscope displays
and uses channel CH1.