User`s guide

7-4
43 In CSD mode a connection could not be established with the destination
modem.
45 In CSD mode after dialing a phone number, the destination modem did not
answer the call.
46 In CSD mode after dialing a phone number, the line was busy.
51 A command was issued to the cellular radio, but the radio did not return a
response within a certain amount of time.
52 The cellular radio returned a response that was corrupt.
53 In CSD mode the cellular radio hung up a connection on its own. This
typically occurs after a loss of carrier from the destination modem.
54 The cellular radio was reset by the processor, but failed to indicate that it
was ready for operation within a certain amount of time.
55 The cellular radio returned a response that was incomplete.
56 When commands are issued to the radio, the radio should always return a
response indicating that the command was accepted and executed. This
error indicates that an unexpected response was received.
57 The cellular radio indicated that it was unable to accept commands or
operate on the cellular network.
58 The response received from the cellular radio could not be recognized.
59 The cellular radio returned a response indicating that it could not accept or
process a command, or could not get a proper response from the cellular
network.
61 In CSD mode the DCM-200 and the central computer exchange specific
information in order to establish a valid connection. During this time the
DCM-200 received a response that was not expected.
62 In CSD mode the central computer did not respond to a request for
communications.
63 In CSD mode after establishing a valid connection with the central computer,
a response was received that was not expected.
64 A stream of data was received that was much larger than anything expected
from the central computer.
65 A command was received from the central computer to change the
configuration memory, but the command contained an error.
66 A command was received from the central computer that was not
recognized.
67 There is an illegal setting in the configuration memory. For instance, the
cellular radio does not support the 850 MHz range, but the DCM-200 has
been configured for 850 MHz operation.
68 A command or data received from the central computer contained an error.
Table 7-1
List of Error Codes (continued)