User`s guide
6-3
6.2.1 Site ID Number
This is the most important item on this screen. It defines the Remote Unit ID number of
the DCM-200. This number must match the number that was programmed into the unit
using MP32 (Chapter-5).
Figure 6-3
Site Information Screen
6.2.2 “IP Enabled” Checkbox
Check this box if the DCM-200 is to use GPRS (Internet) communications.
6.2.3 “Go Transparent” Checkbox
Check this box if the DCM-200 is to communicate with an ANSI C12-complient electric
meter.
6.2.4 “Slave Device” List
If the “Go Transparent Checkbox” has been checked the Slave Device box will be
highlighted. This is the device ID number of the ANSI C12-complient electric meter that
will be connected to this DCM-200. If the electric meter hasn’t yet been defined, pick
any ID number from the list. It will be updated automatically when the electric meter is
configured.