User`s guide

5-10
Starting with firmware version V2.1 a new call retry feature was added that uses
Counter/Status Input-2’s phone number or IP address. See Chapter-7 about this feature
and how to program the phone number or IP Address.
5.5 Programming the Configuration Using the Programming Adapter
Once the configuration parameters have been set, connect the programming cable to
the computer and to the DCM-200’s programming port connector.
On the MP32 screen select the PROGRAM button. At the bottom of the screen will
appear various messages to indicate the progress of the programming operation. The
final message should indicate success. You can review the messages by using the
panning bar to the right of the message window. If there are problems, review the
information in Section 5.3 about the communications setup.
NOTE
When the configuration is changed the DCM-200 will be reset. See Chapter-7 for a
description of the unit’s behavior after a reset.
5.6 Programming the Configuration Over-The-Air
The configuration of one or many installed DCM-200s can be changed over the cellular
network. The data collection software, DC-2000, must be installed and running to
support over-the-air programming. Once the configuration parameters have been set,
select the PROGRAM ACCOUNTS/LISTS button. The next screen will appear:
Figure 5-7
Selection List for Over-the-Air Configuration Changes