User`s guide

5-4
The original MP32 screen will now reappear and the user should select the “DCM-200”
button to start the configuration process. Figure 5-4 depicts the opening screen.
Figure 5-4
MP32 Configuration Screen
If using the programming cable, only the READ, PROGRAM and FIRMWARE UPDATE
buttons are used. If over-the-air programming is used, then the FIRMWARE UPDATE
and PROGRAM ACCOUNTS/LISTS buttons will be used, and the DC-2000 system must
be present and running.
Once a configuration has been defined, it can be saved for future use using the FILE
pull-down menu in the upper left-hand corner of the screen. A previously saved
configuration can be opened in the same manner.
When using the cable, either OPEN a previously saved configuration or perform a READ
operation with the cable connected to the DCM-200.