User`s guide

3-9
to disconnect ac power or any other connector.
2) Locate the J9 connector, near the corner of the radio.
3) See Figures 3-10 and 3-11. Align the mating connector on the capacitor board
with J9’s pins and install the capacitor board.
4) Connect the power connector to J1. The DCM-200 should reset and attempt to
place a call into the central computer. When the radio is activated the LED on
the capacitor board should light if the board is properly aligned. If not, check the
alignment and reinstall the board.
Figure 3-10
Side View of Capacitor Board Installation