Operation Manual

MI 3121H Smartec 2,5 kV Insulation / Continuity Communication

6.6 Communication

Stored results can be transferred to a PC. A special communication program on the PC

automatically identifies the instrument and enables data transfer between the instrument

and the PC.

There are two communication interfaces available on the instrument: USB or RS 232.

The instrument automatically selects the communication mode according to detected

interface. USB interface has priority.

Figure 6.9: Interface connection for data transfer over PC COM port

How to transfer stored data:

 RS 232 communication: connect a PC COM port to the instrument PS/2 connector

using the PS/2 - RS232 serial communication cable;

 USB communication: connect a PC USB port to the instrument USB connector

using the USB interface cable.

 Switch on the PC and the instrument.

 Run the EuroLink PRO program.

 The PC and the instrument will automatically recognize each other.

 The instrument is prepared to download data to the PC.

The program EuroLink PRO is a PC software running on Windows 95/98, Windows NT,

Windows 2000, Windows XP, Windows Vista, Windows 7. Read the file README.TXT on

CD for instructions about installing and running the program.

Note:

 USB drivers should be installed on PC before using the USB interface. Refer to

USB installation instructions available on installation CD.