Manual

REV. 06/07/2019 INSTTE-FDCC1 3
BRAKE LIGHT INSTALLATION (CONT.)
(Figure F)
3
(Figure E)
Brake Light Installation (contin.):
5. Re-install the third brake light with the factory
supplied Torx screws.
6. Run the wiring through the cab of the truck to the
display monitor.
If using a commercial monitor
with
the 4-pin aviation connector, there is no need for the
adapters provided.
If using a RCA input monitor or aftermarket radio use
the provided adapters for RCA video output and
power to the camera.
7. Test the functions of the new LED third brake light.