User Manual

Wireless pairing
The Wi-Fi NVR Kits have been paired with the code at the factory, and can be mapped when powered. If
there is a special situation, you need to re-pair the code. You can right click on the NVR and click
【Add Camera】 in the shortcut menu to enter the Add Camera interface. Click 【Wireless Code
Add】, within 120 seconds of the NVR pair code countdown, long press the button on the camera pigtail
line (about 6 seconds) until the camera infrared light flashes. At this time, the code pairing will be
performed and automatically output images.
Note: The button on the camera pigtail has a
cover, and the cover is waterproof. Cover the
cover when not using the button.
Reset
The camera supports forced recovery of the factory settings by quickly pressing the button on
the tail line 3 times, including network setting parameters and wireless pairing parameters, etc.,
please be careful.