User Manual

Step 3: Set the security question, select the security question 1, 2, 3 by the pull-down operation, and
set the answer to the corresponding security question.
Step 4: Insert the USB flash drive into the device, and click "Export Key > Comfirm > Save". The password
is changed.
Quick Configuration
After the device is powered on, the user can configure the system time, network
configuration, format hard disk, channel addition and other parameters of the device
through the Wizard.
NOTE:
The hard disk must be formatted when installing it for the first time.
Network Configuration
Network parameters must be properly configured before operating the device over the network.
Step 1：On the preview interface, right-click to enter the
menu, and click " > TCP/IP ".
Step 2: Modify the IP address of the device according to the actual network plan. (The default IP
address of the NVR is 192.168.1.88).
Quick Configuration