User Manual

NVR Quick Installation Guide
This NVR is convenient can be easily installed, plug and play and no complex setup needed.
Installation Preparation
Install NVR hard drive. Make sure all power is disconnected before installing. Installation tools: Phillips
screwdriver
(Please use surveillance grade hard disk drive only to avoid poor drive performance)
（1）Unscrew the screws on the back and sides of
the chassis and remove the cover.
(3) Align the hard disk screw holes to the
chassis backplane, and then tighten the screws.
（4）Install the cover and re-attach with screws.
（2）Connect one end of the hard disk power cable
and SATA data cable to the motherboard and the other
end to the hard disk.
Note: Images for instruction use only, your unit may look different but use the same methods