Owner's Manual

Wireless N VR kit Qui ck installati on guide
The signal coverage of the antennas are similar to a circle. Keep all camera antennas
parallel with NVR's antennas as shown in the antenna location diagram. According to
the signal divergence characteristics of the antennas, and in order to guarantee the
Spyclops video quality, cameras antennas must be installed as shown in antenna
location diagram.
6 Hard Drive Install (All NVR's come with a preinstalled 1 TB hard drive.
This section is only for those who would like to upgrade the hard dr ive.)
Install Steps:
1. Unplug and remove power supply from NVR
and let sit for 5 minutes.
2. Remove all screws from the shell and remove
the lid.
3. Unplug the SATA cable from hard dr ive
and remove all screws on the bottom of the
NVR holding the hard dr ive in-place. Place new hard drive in place of the old hard
drive and reconnect the SATA cable and all screws on bottom of the NVR.
4. Place the lid back onto the NVR and place all screws back into its proper place.
5. Place power back to the NVR and power the unit back on.
7 Rear Panel Descriptiontion
Ant enna interface
I IDM I output
Antenna interface
ground wire
VGA ou t put
USB interface
8 Turn on/off
Before powering up the NVR, make sure the correct power supply is connected. Also,
make sure that the power outlet has a good middle ground. After checking the power
connections, power on the NVR. If the power light on the NVR is flashing, this means
the unit is running properly.
03