Installation Instructions

RFASWC
7
Changing Radio Type
Radio Legend
1.Eclipse(Type1)
2.Kenwood
3.Clarion(Type1)
4.SonyandDual
5.JVC
6.PioneerandJensen
7.Alpine
8.Visteon
9.Valor
10.Clarion(Type2)
11.MetraOE
12.Eclipse(Type2)
13.LG
14.Parrot*
15.XITE
* AX-SWC-PARROT is required (sold separately) and the radio must be updated to
rev. 2.1.4 or higher. Additionally, the RFASWC must be updated to the most recent
software available.
Note: If you have a Clarion radio and the RFASWC did not work try the other Clarion
radio type, same for the Eclipse
Dual Assignment Instructions
Note:Seek Up and Seek Down are already set to Preset Up and Preset Down for a
long button press.
1) Turnontheignitionbutdonotstartthevehicle.
2) PressandholddowntheRFASWCbutton,thatyouwanttoassignalongpress
functionto,forabout10secondsuntiltheLEDontheRFASWCinterfacerapidly
flashes.AtthispointreleasethebuttonandtheLEDwillgosolid.
3) PressandreleaseVolumeUpthenumberoftimescorrespondingtothenew
buttonnumberselected.TheLEDwillblinkrapidlywhenVolumeUpispressed
andbacktosolidwhenreleased.ThengotothenextstepwhenVolumeUphas
beenpressedthedesirednumberoftimes.
 Caution: If more than 10 seconds elapses between a Volume Up press, this
procedure will abort, and the LED will go off.
4) Tostorethelongpressbuttoninmemory,pressthebuttonthatyouassigneda
longpressbuttonto(thebuttonhelddowninStep1).TheLEDwillnowgooff
indicatingithasbeenstored.
 Tip: These steps must be repeated for each button you would like to assign
dual purpose action to.
Toresetabuttonbacktoitsoriginaluse,repeatStep1andthenpressVolume
Down.TheLEDwillgooffandthelongpressmappingforthebuttonwillbeerased.