Installation Instructions

5
Setting up the RFASWC
1) PresstheRedandGreenbuttonssimultaneouslyfor5seconds.Thenpress
VolumeUpfor2seconds(thiswillorientateyourbuttondirection).
2) TurntheignitiononandpressVolumeUpontheRFASWC.Thiswill“marry”the
RFASWCtotheinterface.
Remapping the SWC Buttons
Programming
1) Turntheignitionon;theLEDonttheRFASWCinterfacewillstartflashingrapidly,
whichmeanstheRFASWCislookingfortheradio.
Note: If the LED did not start flashing rapidly, press the reset button for 3
seconds, let go, and then proceed to Step 2.
2) Afterafewofseconds,theLEDshouldstopflashingrapidly,andgooutfor
approximately2seconds.
3) TheLEDwillthenflashupto15times,dependingonwhatradiois
connectedtoit.
Tip: Knowing this will help if you need to troubleshoot; refer to the
LED Feedback Legend.
4) Thisistheendoftheautodetectionstage.IftheRFASWCprogrammed
successfully,theLEDwilllightupsolid.
Let’ssayyouhavetheRFASWCprogrammedtoyourradioandyouwantto
changethebuttonassignment.Forexample,youwouldlikeSeekUptobeMute.
Followthestepsbelowtoremapthebuttons:
1) MakesuretheRFASWCinterfaceisvisible,soyoucanseetheLEDflashesto
confirmbuttonrecognition.
Tip: Turning off the radio is recommended.
2) Withinthefirst20secondsofturningtheignitionon,pressandholdVolumeUp
ontheRFASWCuntiltheLEDgoessolid.
3) ReleaseVolumeUpandtheLEDwillgoout.VolumeUphasnowbeen
programmed.
4) RefertotheButtonAssignmentLegendtoreferencetheorderinwhichthe
buttonsneedtobeprogrammed.
Note: If the next function on the list is not on the RFASWC press Volume Up
for 1 second, until the LED comes on, and then release Volume Up. This will
tell the RFASWC that the function is not available and it will move onto the
next function.
5) Tocompletetheremappingprocess,pressandholdVolumeUpontheRFASWC
untiltheLEDgoesout.
RFASWC Installation