Installation Instructions

RFASWC
3
Overview
Mounting the RFASWC Transmitter
1) PlacethebuttonpadintheRFASWCwiththeVolumeUparrow
(▲)inthelocationwhereyouwantittobe.(FigureA)
2) SnapthetrimringontotheRFASWCtosecurethekeypadin
place.(FigureB)
3) UnscrewthestrapcoverfromtheRFASWC.
4) InstalltheRFASWCinthedesiredplaceonthesteeringwheel,
wrappingtherubberstraparoundthesteeringwheel,andthen
throughtheslot.HookittothebacksideoftheRFASWCtosecure
itinplace.(FigureC)
5) Cutofftheunusedportionoftherubberstrap,andthenscrewthe
strapcoverbackontotheRFASWC(donotovertightenthescrew).
(FigureD)
(Figure D)
(Figure C)
(Figure B)
(Figure A)
Note: The reset button is
recessed. An item, such as a
partially unfolded paper clip, is
needed to press the button.