User Manual

Connections and Use

Physical Connections

1. Screw in the Wi-Fi Antenna

2. Plug in all to be used connections Including:

Ethernet LAN (Skip the Ethernet cable if you will be

using Wi-Fi)

Connected equipment power cables

3. Insert the female end of the included 6ft power cord

into the PR-W3PI

4. Plug in the Male end of the included 6ft power cord into

the main outlet on your wall

Wi-Fi Setup

If using the Wi-Fi connection, follow these

instructions

1. Plug in the included power cable to the PDU and to the

AC main outlet on the wall. Wait approximately 15-30

seconds, the power button will begin to flash

2. Scan for Wi-Fi on your Wi-Fi enabled device with a

web browser

3. Connect to the Wi-Fi SSID of the PDU

The SSID of the PDU will be “Metra-xxxxxxxxxxxx” where

the “x” are the MAC address or device ID of the PDU. Verify

the code of the SSID matches the MAC address of the PDU

with the sticker that is attached to the bottom of the PDU

4. In a web browser go to “192.168.4.1”

5. Go to “Network”