User Manual

Replaceable Surge Modules

Remove

1. Firmly grasp the front top and bottom lip of the

surge module

2. Pull the surge module from the front of the PDU

A slight side to side motion may help release the surge

module from the PDU

Replace

1. Ensure the correct module is being inserted into the

correct slot on the PDU

2. Gently slide the surge module into the PDU until you

feel resistance

3. Firmly push the surge module into the PDU until you hear

and feel a click

DO NOT: Smack the surge module into the slot

6. Click “SCAN NETWORKS”

The network mode can also be changed before scanning.

For ease of setup we’ll use the default DHCP settings.

7. Select the desired network SSID

NOTE: the PDU requires a 2.4Ghz Wi-Fi connection.

8. If required enter the password for the Wi-Fi connection

9. Click “Save”

The PDU will now connect and reboot. After it has

rebooted it will attempt to connect to the Wi-Fi signal.

10. Once the PDU has been connected to the network and

has access to the web, proceed to the next steps