User Manual

9
Installation
Wall Tap / Plug
1. Plug the PDU into an open outlet
2. Rotate PDU to desired position
3. Plug in device that is to be powered
Connections and Use
Physical Connections
1. Plug in device that is to be powered to PDU outlet.
Wi-Fi Setup
If using the Wi-Fi connection, follow these
instructions
1. Wait approximately 15-30 seconds, the power button will
begin to flash
2. Scan for Wi-Fi on your Wi-Fi enabled device with a
web browser
3. Connect to the Wi-Fi SSID of the PDU
The SSID of the PDU will be “Metra-xxxxxxxxxxxx” where
the “x” are the MAC address or device ID of the PDU. Verify
the code of the SSID matches the MAC address of the PDU
with the sticker that is attached to the bottom of the PDU
4. In a web browser go to “192.168.4.1”
5. Go to “Network”
6. Click “SCAN NETWORKS”
The network mode can also be changed before scanning.
For ease of setup we’ll use the default DHCP settings.
7. Select the desired network SSID
NOTE: the PDU requires a 2.4Ghz Wi-Fi connection.
8. If required enter the password for the Wi-Fi connection
9. Click “Save”
The PDU will now connect and reboot. After it has rebooted
it will attempt to connect to the Wi-Fi signal.
10. Once the PDU has been connected to the network and
has access to the web, proceed to the next steps