Installation Instructions

5
REV. 9/24/2020 INSTMPS-DPSL-BT
1. Install the MPS-DPSL-BT harness and make all necessary connections but leave the
amp turn-on wire disconnected.
2. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the MPS-DPSL-BT harness harness into the left side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
3. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector
from the MPS-DPSL-BT harness into the right side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
4. Plug the 16-pin and 20-pin connectors from the MPS-DPSL-BT harness into the
circuit board. (Figure A)
5. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location. Make sure the harnesses are pointing down to ensure that no outside
elements can enter the enclosure.
I N S TALLATIO N
Cap (with O-ring)
Case
MPS-DSPL-BT
Circuit Board
AXDSP L
Harness
16-Pin 20-Pin
Gasket
Zip-tie Mounts
(Figure A)