Instruction Manual

HE-BRK-FD4
Install instructions
7
-Routing
9. Using the factory harness as a guide, route the
harness down and out the driver side fog light cavity.
(Figure 14 and Figure 15)
10. Plug in the driver side “set 1” connector to the
center most cube light, “set 2” connector to the
middle cube light, and “set 3” connector to the cube
light nearest the driver side.
*If using less that (3) lights, omit the same set(s) of
connectors on both sides of the vehicle.
11. Inside the driver front wheel well, locate the front
facing screw clip. Using a Philips and panel tool,
remove the clip. Repeat on the passenger side.
(Figure 16 and Figure 17)
Figure 15
Figure 16
Figure 17
Figure 14