Instruction Manual

HeiseLED.com
Technical Support: 386-257-1187
HE-BRK-FD4
Install instructions
4
-OE switch panel wiring
If the vehicle is equipped with the factory switch
panel continue, if not go to harness hardwire on
page 10.
1. Pull the hood release handle near the driver kick panel
to release the hood.
2. Open the hood and locate the auxiliary switch wires
located in the driver side corner of the engine bay by the
firewall. (Figure 10)
3. The included harness is intended to be connected to the
AUX 4, AUX 5, and AUX 6 switch wires, which are brown
(set 1), blue/orange (set 2), and yellow/orange (set 3)
respectively. (Figure 11)
4. Remove the protective cover from the auxiliary brown,
blue/orange, and yellow/orange wires, strip off a ¼” of
insulation from each, and crimp to the harness’s respective
wire.
5. Ground the black wire from the harness marked “chassis
ground” to a factory grounding point in the engine bay.
Figure
11
Figure 10