Instruction Manual

HeiseLED.com
Technical Support: 386-257-1187
HE-BRK-FD4
Install instructions
2
-Bracket mounting
1. Locate the (3) factory bolts at the top front edge
inside each of the fog light cavities. (Figure 1 and
Figure 2)
2. Using a T40 Torx®, remove these (6) bolts. (Figure 3)
3. Align the brackets so the bracket hump rises front
to back, and the sweep angles towards the side of the
vehicle. (Figure 4 and Figure 5)
4. Mount the desired lights to the bottom side of the
brackets (in a hanging orientation). Do not fully
tighten at this time.
5. Side the bracket between the front tire and
bumper, up into the fog light cavity.
6. Using the factory bolts mount the brackets into
place, and fully tighten the (3) factory bolts to 18 lb.ft
(25Nm). Repeat for the other side.
Figure 2
Figure 3
Figure 4
Figure 1
Figure 5