Owner's Manual

Instruction Manual
Connect USB Power cable to USB Power supply.
Do NOT use USB port on display.
Connect long HDMI cable to the input of GA2.
Connect .5 Meter cable from output of GA2 to input of Display.
Turn system on with 4K source at 18Gbps (Color Sub Sampling of 4:2:2 or greater).
Programming:
Set Threshold level to "Low" (least amount of system noise).
Set EQ Level to Level 1 "B-B ".
Model No .: HDMI-GA2
Using the Program Chart* Increase EQ one level at a time, waiting 3 seconds at each change until picture synchronizes.
*Program Chart
Level 1
"BB"
Level2
"BA"
Level 3
"AC"
Level4
"BC"
Level5
" CB "
Level6
"AB"
Level?
" AA"
Level8
" CA "
Level9
"CC"
Once picture synchronizes increase setting one more level to provide headroom.
If picture sync holds then leave at this setting.
If picture sync is lost, reduce level to previous setting.
Increase input threshold from low to high and still maintain picture sync.
Use highest setting.
If your picture is not stable repeat above process with ''Threshold" set to "Medium ".
LEDs
DO- Green indicates that video is present.
D1- Green indicates that video is present.
D2- Green indicates that video is present.
D3- Green indicates that video is present.
Power-Red indicates that there is 5 Volts provided to the HDM-GA2.
For more information visit www.metrahometheater.com
For installation video visit www.youtube.com
Metra Home Theater Group