Installation Instructions

ManualsBrandsMetra ManualsCar HarnessMetra Saturn Car Harness

GM ONSTAR LAN DATA BUS INTERFACE

GMOS-LAN-06

1-800-221-0932

www.axxessinterface.com

APPLICATIONS

* READ IMPORTANT WARNING ON PAGE 1 BEFORE

ATTEMPTING ANY INSTALLATION

The GMOS-LAN-06 is designed to retain Onstar in the Saturn

applications listed below when replacing the OEM radio with

an aftermarket one.

Saturn

• Ion 2006-07

• Vue 2006-07

INTERFACE COMPONENTS

• GMOS-LAN-06 Interface

• 10 pin harness with leads

• 12 pin to 30 pin Saturn harness

Summary of content (8 pages)

PAGE 1
GM ONSTAR LAN DATA BUS INTERFACE GMOS-LAN-06 Installation Instructions * READ IMPORTANT WARNING ON PAGE 1 BEFORE ATTEMPTING ANY INSTALLATION The GMOS-LAN-06 is designed to retain Onstar in the Saturn applications listed below when replacing the OEM radio with an aftermarket one. APPLICATIONS Saturn • Ion • Vue 2006-07 2006-07 INTERFACE COMPONENTS • GMOS-LAN-06 Interface • 10 pin harness with leads • 12 pin to 30 pin Saturn harness 1-800-221-0932 www.axxessinterface.
PAGE 2
GMOS-LAN-06 * READ IMPORTANT WARNING BEFORE ATTEMPTING ANY INSTALLATION * IMPORTANT WARNING THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST BE CAREFULLY FOLLOWED. THE INSTRUCTIONS ARE WORDED IN SUCH A MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE OF COMPLETING THESE TYPE OF ELECTRONIC INSTALLATIONS.
PAGE 3
GMOS-LAN-06 TOOLS REQUIRED FOR INSTALLATION • Cutting Tool • Tape • Crimping Tool • Connectors (ie: butt-connectors, bell caps, etc.) WIRING CONNECTIONS * Important: Before beginning any of the following, disconnect the negative battery terminal to prevent accidental short circuit. FOR INSTALLATION OF AFTERMARKET RADIO ONLY: From the 10 pin harness: 1. Connect the red wire to the ignition/accessory wire of the aftermarket radio. 2.
PAGE 4
3 CHIME VOLUME ADJUSTMENT RADIO RF+ RF- BLUE/WHITE RED LF+ LF- DIAGRAM R 1 ORANGE ORANGE/WHITE L LRRR+ R RR- L LR+ GMOS-LAN-06 BLK YEL GM 30 PIN BLACK/YELLOW BLACK/WHITE 7 WIRES GMOS-LAN-06
PAGE 5
GMOS-LAN-06 FOR AFTERMARKET RADIO AND AMPLIFIER (See wiring diagram on page 6) CONNECTIONS TO BE MADE ON THE 10 PIN HARNESS: 1. Connect the red wire to the ignition/accessory wire of the aftermarket radio. 2. Connect the blue/white wire to the amp turn on wire of the aftermarket radio and to the blue/white wire in the 24 pin harness. 3. White NOT USED 4. White/black NOT USED 5. Gray NOT USED 6. Gray/black NOT USED Connect the brown wire to the mute wire of the aftermarket radio.
PAGE 6
GMOS-LAN-06 8. Cut the white/black wire about half way between the two plugs. Connect the white/black wire from the 24 pin plug to amplifier’s left front negative speaker output wire. Connect the white/black wire from the 12 pin plug to the negative speaker wire of the Metra SP-2003 or equivalent. 9. Cut the gray wire about half way between the two plugs. Connect the gray wire from the 24 pin plug to amplifier’s right front positive speaker output wire.
PAGE 7
6 CHIME VOLUME ADJUSTMENT RF+ RF - LF+ LF- RED BLUE/WHITE 10 PIN RADIO X X X X + LR LR + RR RR BLACK/YELLOW BLACK/WHITE LF+ LF RF + RF - TO AFTERMARKET REAR AMPLIFIER GM 30 PIN TO AFTERMARKET FRONT AMPLIFIER SP-2003 ORANGE/WHITE ORANGE GMOS-LAN-06 BLK YEL OPTIONAL SP-2003 12 PIN REQUIRED AFTERMARKET RADIO AND AMPLIFIER WIRING GMOS-LAN-06
PAGE 8
GMOS-LAN-06 INSTALLING THE GMOS-LAN-06 1. With all connections completed, plug the 14 and 12 pin harnesses into the GMOS-LAN-06. 2. Reconnect the negative battery terminal. 3. Plug the 30 pin GM harness into the vehicle side harness, and plug the aftermarket radio harness into the aftermarket radio. 4. Cycle the key by turning the ignition on then back off, then back on again to test the radio. TESTING THE GMOS-LAN-06 1. Turn the ignition on, and then turn the aftermarket radio on. 2.