Owner's Manual

120 E5000
2
SPDT Relay
APPLICATION: REMOTE TRUNK RELEASE
In this application, you use the remote control output from your car
security system to open your trunk without the key. You must have
an existing power-assisted trunk release switch in your vehicle.
You need a constant (unswitched) source of 12 volt power for the
relay’s green wire. You can tap into your fuse panel or run a wire
directly to your positive battery terminal. If you run a wire to your
battery, we recommend installing a 30 amp fuse in line, close to
the battery connection.
If your trunk switch doesn’t work unless the key is on, connect the
red (30) wire together with the green (86) wire to the unswitched 12
volt power source and connect the white (87) wire to the output side
of the trunk release switch.
APPLICATION: POWER DOOR LOCK SYSTEM
To install aftermarket power door locks and activate them from your
security system remote control, you need an “actuator” for each door
and two relays.
You need a constant (unswitched) source of 12 volt power for the
relay’s green and white wires. You can tap into your fuse panel or
run a wire directly to your positive battery terminal. If you run a wire
to your battery, we recommend installing a 30 amp fuse in line, close
to the battery connection.
= Indicates wire splice
Copyright 2015 Crutchfield Corporation
Make wiring connections following instructions on page 3.
Green (86) - Unswitched 12 Volt power source
White (87) - Connect to one side of your
existing trunk release switch (red wire goes
to the other side of the switch)
Black (85) - Connect to remote output lead
from your security system
Blue (87a) - Not used (tape off)
Tape off any unused wires.
White (87) - Unswitched 12
volt power source
Black (85) - UNLOCK output from
security system (negative trigger)
Red (30) - Connect to
blue actuator wire
Red (30) - Connect to
green actuator wire
Blue (87a) - Connect to chassis ground
Black (85) - LOCK output from
security system (negative trigger)
Tape off any unused wires.
Make wiring connections following instructions on page 3.