Owner's Manual

DP-7363B
4
(Figure A) (Figure C)
(Figure B) (Figure D)
Kit Assembly
ISO DIN radio provision with pocket
1. To remove the factory steering
column cover from the factory
dash panel, pry (4) round retaining
clips from where the leather meets
the large panel. (Figure A)
2. Place the leather cover over the
Metra radio trim panel, place the
steering column bracket over the
leather and secure with the (4)
#4 x 3/8” Phillips screws supplied.
(Figure B)
3. Mount the pocket to the radio
brackets with the (4) #8 x 3/8”
Phillips screws supplied.
(Figure C)
4. Remove the metal “DIN” sleeve
and trim ring from the
aftermarket radio.
5. Slide the radio into the assembly
and secure with screws supplied
with the radio. (Figure D)
6. Locate the factory wiring harness
and antenna plug in the dash and
make all necessary connections
to the radio. Metra recommends
using the proper mating adapters
from Metra and/or AXXESS.
7. Mount the Metra radio assembly
into the dash.
8. Snap the Metra radio trim panel
and steering column cover into the
dash and reassemble the dash in
the reverse order of disassembly.