HOME THEATER GROUP HDMI® POE EXTENDER OVER SINGLE CAT CS-HDCS5EXTSRPOE User Manual 460 Walker Street Holly Hill, FL 32117-2699 &—0 HOME SUPPORT www.MetraHomeTheater.
Thank you for purchasing this product. for optimum performance and safety,please read the instructions carefully and keep the manual for future reference. + Important Safety Notice Please read below safety instructions carefully before installation and operation: 1. Do not mix up the transmitter unit (TX) and the receiver unit (RX), IR blaster extension cable and IR receiver extension cable before installation. 2. Do not hot plug when it is working. 3. Use DC power supply only.
power up, as the Receiver unit is powered by the Transmitter unit through network cable). This HDMI Extender support IR pass back for remote control source device easily. This product is perfect for AV transmission in applications of HD conference system, HD video shooting, HD multimedia education system, HD digital advertising and signage etc. » Product Features 1. Include a transmitter unit (TX) and a receiver unit (RX), working as a pair. 2. Support resolution is up to full HD 1 080p@60Hz. 3.
cr] Ji—— cr] i= @— (Em—= > IR blaster IR receiver Power supplicates extension cable PCs extension cablecasts « Installation Requirements 1. HDMI source device(computer graphics card, DVD,PS3, HD monitoring equipment etc). 2. HDMI display device like HDTV, HDTV, projector with HDMI port. 3. OUTPOST CAT6/6A/7 cable, follow standard |EEE-568B. » Penal Description 1.
2.Receiver unit (RX) ® DVD power input ® LENGTH: for adjusting to the ® HDMI signal output length of network cable ® IR signal input to connect with ® Signaler input IR receiver extension cable ® Indicator led: it lights on all the time when HDMI signal transmission, flashes when no signal transmission « Installation and Connection 1.How to make a CAT6/6A/7 network cable Follow the standard of |IEEE-568B 1. white and orange; 2. orange; 3. white and green; . i 4. blue; 5. white and blue; 6. green; Ni 7.
3.Connection instruction 3.1 Connect source device to Transmitter unit (TX), and display device to Receiver unit (RX) via HDMI cables 3.2 Connect Transmitter unit (TX) and Receiver unit (RX) via network cables (CAT6,CAT6A or CAT) 3.3 Plug the power supply to Transmitter unit only, each unit will power up then initialize itself, this HDMI extender works [NOTE] It is recommended to use a length range within 15~ 50m network cable.
x0 20 5.4 There are 7 build-in DID status, and the default DID is 720P60Hz CH, and others could be selected by the DID switch in the transmitter,the detail Setting Information shown as below: Vppe]| Switch UP: use the Arabic numeral "1" to represent N123 ‘mea Switch DOWN : use the Arabic numeral "0" to represent NZS Switch Status whitehead | switch-3 | switch-3 DID information o o o 720P@50Hz 21CH 1 o o 720P@50Hz 1080i@60Hz 1080i@60Hz 1080P@60HZz 1080P@60Hz 7.
« Specification Item Specification HDMI signal HDMI 4a PHD HDCP1 .2a Support 480i@60Hz, 480p@60Hz, 576i@50Hz, 576p@50Hz, resolutions 1 3D:1 080p@60HZ Network cable Low resistance and consumption oxygen-free copper core (CAT, CATBOAT.
