HOME THEATER GROUP 1 x 4 H DMI Extender Splitter CS-1X4HDSPLEXT ,.-- 0 . = . ,s?.@~ - I I I I I I @ - - - - ~ ~ .~~ -~•~1§£1§i] 0 I I User manual . . I I I I . = ,2@.s?- = . ,s?. @~ - I I I I I I @ . . I I I I . = ,2@.s?- = . I I I I I I @ -0 0 . . I I I I . ,s?. @~ - = ,2@.s?- = ,s?. ® ~ MetraHomeTheater.
• IMPORTANT SAFETY INSTRUCTIONS 1. Do not mix up the Transmitter and Receiver, and the IR blaster and IR receiver. 2. Do not plug-in/out the cables ,when it is in using. 3. Use DC SV power supply only. Make sure the specification matched if using 3rd party DC adapters. 4. Support power from transmitter to receiver unit over the CAT6 cable.
• FEATURES 1. Distribute 1 HDMI source to 4 HDMI displays over network cable simultaneously. 2. Support one HDMI Loop-out. 3. Compatible with CAT6/6a/7 network cables. 4. The transmission distance is up to 40m/131ft. 5. The highest resolution supported is 1920x1080@60Hz. 6. Support 20~60Hz IR pass back. 7. Support EDID Setting function. 8. Support power from transmitter to receiver unit over the CAT6 cable. 9. Plug and play. 10. Wall-mounted function, easy installation. • INSTALLATION REQUIREMENTS 1.
CD Power input ( DCSV) ® @ EDID switch ® ® IR signal output to connect (J) with blaster extension cable @ HDMI input ® l H DMI output RJ45 signal output Power/ signal indicator Reset button 2.
• Installation Procedures 1. How to make a CATS/SE/6 network cake Follow the stanard of IEEE-568B: 1- Orange/white 2- Orange 3- Green/white 4- Blue 5- Blue/white 6- Green 7- Brown/white 8- Brown 2. Connection DVD 6vo I l HDMI input HDMI extender splitter Cable HDMIOut Receiver TV i--+@) TV TV Remarks: Please do not remote control two or RX units ' IR cable at the same time, which to avoid interference.
3. Connection instruction: 1) Connect the HDMI signal source device to the Transmitter HDMI input port with HDMI cable. 2) Connect IR blaster to EXTENDER IR OUT 3) Connect the Transmitter RJ45 port to HDMI EXTENDER RX's Rj45 input port by network cable. 4) Connect HDMI EXTENDER RX's HDMI output port to HDMI display's HDMI input port by HDMI cable and set the HDMI display's signal source to be H DMI port.
• FAQ Q: No image or audio output on display? A: 1) Please check whether display on standby mode; 2) Please check whether display HDMI signal channel in accord with HDMI input port; 3) Please check whether " LINK" LED on RX side keeps on, LED flash means RX does not receive signal from TX; 4) Please check whether signal indicator LED on TX turns blue, LED on red means no input signal; 5) Please check whether input resolution supported by this product.
EDID Support EDID setting function Working temperature 0°C ~ 60°( Power supply DCSV/3A Power Consumption
SALES 866-839-9187
