Owner's Manual

2) Connect IR blaster to EXTENDER IR OUT.
3) Connect the Transmitter RJ45 port to HDMI EXTENDER RX 's RJ45
input port by network cable.
4) Connect HDMI EXTENDER RX 's HDMI output port to HDMI display's
HDMI input port by HDMI cable and set the HDMI display's signal
source to be HDMI port.
5) Supply the power{Power's signal light is red,when there are signal
input then the power light is blue),the product will work.
4. EDID Setting
1) HDMI source device reads the EDID informa t ion of the transmitter
(TX) and then output the relative HDMI signal format .
2) There are 8 build - in EDID status, and others could be selected by
the EDID switch in the HDMI extender splitter(transmitter), the
detail Setting Information show n as below :
! """ Sw itch UP: use the Arabic numeral ·1 • to represent
N 1 2 )
w~~~ I I Switch DOWN : use the Arabic numeral ·o· to represent
SWl
SW2 SW3
EOIO Mode
..
0 0 0
720P@50Hz 2. lCH
1
0 0
720P@50Hz 7.lCH
0 1 0
1080 i@60Hz 2.lCH
Switch
1 1 0
1080i@60Hz 7. lCH
Statu s
0
0 1
1080P@60 2. lCH
1 0 1
1080p@60Hz 7.lCH
0 1 1
Read Loop-out{if not connect
the loop- out show default)
1 1
1 Default 720P@S0Hz 2. lCH