Owner's Manual

(D Power input ( DCSV)
@ EDID dip switch
® IR signal output to connect
with blaster extension cable
© HDMI input
2.Receiver unit (RX)
0
0
LI NK
RESET
7
®
® HDMI output
© RJ45 signal output
(J) Power/ signal indicator
® Reset button
0
M IN 0
0
©
(D LENGTH: for adjusting to the length © DVSV power input (OPTIONAL)
of network cable © HDMI signal output
0 RJ45 signal input © IR signal input to connect with
© RJ45 indicator led it lights on all the IR receiver extension cable
time with HDMI signal transmission,
flashes with no signal transmission
Remarks: The LENGTH key is designed for switching between automatic
and manual setting to adjust cable length . Powered on wi thout any
operation, extender works wi th parameter set and memorized before .
Powered on and then press LENGTH key, The first two press, it wi ll
entering automatic mode to adapt cable length . The following 12 times
of pr~ing, it will entering manual mode in 12 levels to meet different
cable length . After all 12 levels of press, it will enter ing auto mode
again and into next loop.