Owner's Manual

• IMPORTANT SAFETY INSTRUCTIONS
1. Do not mix up the Transmitter and Receiver, and the IR blaster and
IR receiver.
2. Do not plug-in / out the cables , when it is in using.
3. Use DC SV power supply only . Make sure the speci ficat i on matched
if using 3rd party DC adapters.
4. Support power from transmitter to receiver unit over the CAT6 cable.
• INTRODUCTION
This HDMI extender splitter includs one transmitter and two receivers,
extend 1 HDMI source to 2 HDMI disp lays over single CAT6/6a/ 7 cable
up to 40m/131ft . The highest resolution supported is 1920 x l080 @60Hz,
and it supports IR passback, EDID pass through and only one power
adapter for the transmitter is needed, the Receiver is powered by the
transmitte r over CAT6 cable. Ideal solut i on for HDMI exhibit ion, Video
conference and show center , ect .
• PACKAGE CONTENTS
Tr ansmitter unit x lpc s
User Man u al x lp cs
Re ce iv er unit x2pcs
cm:(JmD==
(ft)==
IR blaster extension
cable x lpc s
DC SV /2 A x lpc s
~
@)Jnl=
IR rece iv er ex ten si on
cable x2 pcs