HOME THEATER GROUP 1 x 2 HDMI Extender Splitter CS-1X2HDSPLEXT --- - -- -- - ,--- 0 0 User manual -- - -- - -- - - - ~ ~ ~~ §B 1111~1~1 . - I I ~ ~ (§)DCW I . I I I I I . - . 0 I I @ , -0 •OUT(§) (;) ..2. 1 . I I ~ 0 I I I I I I - I ~-(;) ,.2. @..... .I @ . 0 '"-@..2 MetraHomeTheater.
• IMPORTANT SAFETY INSTRUCTIONS 1. Do not m ix up the Transmitter and Receiver, and the IR blaster and IR receiver. 2. Do not plug-in/ out the cables ,when it is in using. 3. Use DC SV power supply only. Make sure the spec ificat ion matched if using 3rd party DC adapters. 4. Support power from transmitter to receiver unit over the CAT6 cable.
• FEATURES 1. Distribute 1 HDMI source to 2 HD displays over network cable simultaneously. 2. Support one HDMI Loop-out. 3. Compatible with CAT6/6a/7 network cables. 4. The transmission distance is 40m/131ft. 5. The Highest resolution is up to 1920xl080@60Hz. 6. Support 20 ~ 60Hz IR pass back. 7. Support EDID. 8. Support power from transmitter to rece iver unit over the CAT6 cable. 9. Plug and play. 10. Wall - mounted function, easy installation. • INSTALLATION REQUIREMENTS 1.
0 0 (D Power input ( DCSV) @ EDID dip switch ® © ® IR signal output to connect (J) with blaster extension cable ® © LINK RESET 7 ® HDMI output RJ45 signal output Power/ signal indicator Reset button HDMI input 2.
• Installation Procedures l.How to make a CATS/SE/6 network cake Follow the stanard of IEEE-568B: 1357- Orange/white Green/white Blue/white Brown/white 2- Orange 4- Blue 6- Green 8- Brown 2. Connection DVD .... - HDMI input HDMI extender splitter I UT l-) DC IV £DID IR OUT Cable HDMIOut ReGeiver TV r -+@ I ' f I D TV D I TV Remarks: Please do not remote control two or RX units' IR cable at the same time, which to avoid interference. 3.
2) Connect IR blaster to EXTENDER IR OUT. 3) Connect the Transmitter RJ45 port to HDMI EXTENDER RX's RJ45 input port by network cable. 4) Connect HDMI EXTENDER RX's HDMI output port to HDMI display's HDMI input port by HDMI cable and set the HDMI display's signal source to be HDMI port. 5) Supply the power{Power's signal light is red,when there are signal input then the power light is blue),the product will work. 4 .
• FAQ Q: No image or audio output on display? A: 1) Please check whether display on standby mode; 2) Please check whether display HDMI signal channel in accord with HDMI input port; 3) Please check whether " LINK " LED on RX side keeps on,LED flash means RX does not re ceive signal from TX. 4) Please check whether signal indicator LED on TX turns blue, LED on red means no input signal; 5) Please check whether input resolution is supported by this product.
Working temperature 0°C ~60°C Power supply DCSV/2A Power Consumption
