Technical Document

(Figure C)
Installation Instructions
1. Connect one end of the resistor to the Blue/Yellow wire from the radio. Connect the other end of the resistor
to the Brown wire from 3.5mm adapter included with the ASWC-1. (Figure A)
2. Proceed with programing the steering wheel controls. Once the ASWC-1 interface shows the correct radio (5
LED flashes), remove the resistor.
3. Reconnect the Blue/Yellow and Brown wires without the resistor in place. (Figure B)
4. Test the steering wheel controls for proper functionality.
5. The installation is now complete.
(Figure A)
(Figure B)