Technical Document

Table Of Contents

Steering Wheel Controls With

New JVC & Kenwood Radios

• Locate the main connector on the back of the radio. These radios use an ISO/EURO (1784 shell) radio connector.

(Figure A)

• The SWC wire from the radio can be found in the bundle of wires above the main connector, labeled REMOTE

CONT. (Figure B)

• This installation step will require a 10k ohm ¼ watt resistor (sold separately). (Figure C)

(Figure A)

(Figure B)

ASWC-1 Technical Document #100A

PAGE 1
ASWC-1 Technical Document #100A Steering Wheel Controls With New JVC & Kenwood Radios • • • Locate the main connector on the back of the radio. These radios use an ISO/EURO (1784 shell) radio connector. (Figure A) The SWC wire from the radio can be found in the bundle of wires above the main connector, labeled REMOTE CONT. (Figure B) This installation step will require a 10k ohm ¼ watt resistor (sold separately).
PAGE 2
(Figure C) Installation Instructions 1. Connect one end of the resistor to the Blue/Yellow wire from the radio. Connect the other end of the resistor to the Brown wire from 3.5mm adapter included with the ASWC-1. (Figure A) 2. Proceed with programing the steering wheel controls. Once the ASWC-1 interface shows the correct radio (5 LED flashes), remove the resistor. 3. Reconnect the Blue/Yellow and Brown wires without the resistor in place. (Figure B) 4.
PAGE 3
Manual Program As an alternative, the radio can also be manually programmed to the ASWC-1 interface. 1. Program the interface to the vehicle following the vehicle specific document. 2. Turn the radio off. 3. Cycle the key off, then back on. 4. Wait until the interface’s light flashes Green one time then goes out. 5. Press and hold the Volume Down button on the steering wheel until the interface’s light turns solid Red, then release.